Robocup Rescue with NXT-G: Introduction
The Topics
- 1. About Robocup Rescue
- 2. NXT-G Revision
- 3. Loop, Light Sensor & Switch Block
- 4. Controlling the Motors
- 5. Running the Motors Unlimited
- 6. Build the CE Race Bot
- 7. Bounce Around the Square (a) | 8. (b) | 9. (c) | 10. (d)
- 11. Follow the Line - Single Sensor
- 12. Tight Bends
- 13. Find the Can (a) | 14. (b) | 15. (c)
- 16. Turn on Green (a) | 17. (b) | 18. (c) | 19. (d) | 20. (e)
- 21. The Water Tower (a) | 22. (b) | 23. (c)
- 24. Bridge and Speed Bumps
- 25. Find the Can with the Ultrasonic Sensor
Talk- through #1. About Robocup Rescue
Talk-through #2. NXT-G Revision
Talk-through #3. Loop, Light Sensor & Switch Block
Talk-through #4. Controlling the Motors
Talk-through #5. Running the Motors Unlimited
Talk-through #6. Build the CE Race Bot
The build instructions in this talk-through are here:
clubengineer.org/online-learning/robotics/build-instructions
Talk-through #7. Bounce Around the Square (a)
Talk-through #8. Bounce Around the Square (b)
Talk-through #9. Bounce Around the Square (c)
Talk-through #10. Bounce Around the Square (d)
Talk-through #11. Follow the Line - Single Sensor
The work sheet we use in this talk throuh is here.
